Flits toebehoren / Flash accessories
|
|

|
U
ziet hier 3 flitsbeugels en 3 flitskabeltjes. Flitsbeugels zijn nodig voor
gebruik bij camera's waarop geen flitsschoentje is aangebracht. Ze worden bevestigd
op de statiefaansluiting. Bijkomend voordeel is dat de flitser daardoor
verder van de lens af zit en er daarom vrijwel geen rode ogen voorkomen bij
het gebruik ervan. v
De
bovenste flitsbeugel (zonder greep) is van Rowi Germany en is uitschuifbaar.
Ik heb hem in 2002 gekregen van Wim Poell uit Mheer. v
De
middelste flitsbeugel is van Wata Western Germany en is door mijzelf gekocht
rond 1972 voor gebruik met de Pentor Super TL, die geen flitsschoentje had.
Ook bij mijn volgende camera, een Pentax ME Super, heb ik hem gebruikt, omdat
de camera met deze beugel zo stevig in de hand ligt. De statiefschroef is
verstelbaar en daarmee ook de hele greep. v
De
onderste beugel is van Hama; land van herkomst onbekend. De statiefschroef is
verstelbaar en daarmee ook de hele greep. Ik heb hem rond 1990 gekregen van
mijn schoonvader Bert Verhoef. v
Een
vierde flitsbeugel kreeg ik in september 2008 van de fam. Oosting uit Son en
die staat nog niet op de foto. De beugel is van TSC uit Japan en is
inklapbaar. Het kartonnen doosje is er ook.
|
Here you see 3 flash unit holders and 3 flah
cords. Flash unit holders are needed for use on camera's without an accessory
shoe. They are attached to the camera on the tripod mount. An extra advantage
is that the flash unit is further away from the exposure lens and because of
that the red eye problem is almost non-existent. v The
upper flash unit holder (without grip) is from Rowi Germany and is extensible.
I obtained it in 2002 from Wim Poell from Mheer. v The
flash unit holder in the middle is from Wata Germany and was bought by myself
around 1972 for use with my Pentor Super TL, that did not have an accessory
shoe. I also used it on my next camera, a Pentax ME Super, because of the
firm grip you get on the camera when using such a holder. The tripod screw is
adjustable and with that the whole holder. v The
lower holder is from Hama; country of origin not specified. The tripod screw
is adjustable and with that the whole holder. I obtained it around 1990 from
my father-in-law Bert Verhoef. v A
fourth flash bracket is not yet shown on the picture and is a gift from Mr.
Oosting in September 2008. The bracket is made by TSC Japan and can be
folded. I also own the cardboard box. Of the 3 flash cords the upper one belongs to
the Voigtländer electronic flash, the one in the middle to the Agfa
electronic flash and the lower one is a flash cord with a length of 2 meters
for use of a remote flash unit. |